5
Installation
The minimum distance between the supporting surface for the cooking equipment on the hob and the lowest part of the range hood must
be not less than 67cm from gas hob/electric hob or mixed cookers.
If the instructions for installation for the gas hob specify a greater distance, this must be adhered to.
Electrical connection
The mains power supply must correspond to the rating indicated on the plate situated inside the hood. If provided with a plug connect the
(direct mains connection) or if the plug is not located in an accessible area, after installation, apply a double pole switch in accordance with
standards which assures the complete disconnection of the mains under conditions relating to over-current category III, in accordance with
installation instructions.
Warning!
is correctly assembled.
Mounting
Very heavy product; hood handling and installation must be carried out by at least two persons/qualified and experience installer.
Before beginning installation:
•
Check that the product purchased is of a suitable size for the chosen installation area.
•
•
Check (for transport reasons) that there is no other supplied material inside the hood (e.g. packets with screws (*), warranty card &
This hood are to be mounted with ventilation system only.
user manual, eventually removing them from the box and keeping them.
•
If possible, disconnect and move freestanding or slide-in range from cabinet opening to provide easier access to rear wall/ceiling.
for assembling the unit. Cover that surface with a protective covering and place all canopy hood parts and hardware in it.
•
In addition check whether near the installation area of the hood (in the area accessible also with the hood mounted) an electric socket
is available and it is possible to connect a fumes discharge device to the outside (only suction version).
•
Carry out all the masonry work necessary (e.g. installation of an electric socket and/or a hole for the passage of the discharge tube).
•
Install the cooker hood on the metal bracket fixed at the wall. Ensure the hood is well installed and aligned.
•
Refer figure 2:
Ensure 5 wall plug with proper screw into the metal bracket hole in the middle, to prevent the cooker hood from vibration
or falling off from the wall.
•
Ensure the wall is solid & good for hood fixing, drilling & installation work to be carry out.
INSTALATTION GUIDE
provided must carefully observed and install by experienced and qualified installers only.
- This cooker hood must only install with Aluminium ducting only and meant for ventilation system. (The Cooking residues such as
heat, hot air and ordour, to be channel out from the kitchen).
