6. Place the cabinet installation template facing
down and stick the template on the bottom of
the upper cabinet, then open and drill holes
according to the template, after done those holes,
tear off the template from the cabinet.
7. Remove the protective film from the range hood
surface.
9. Use one hand lightly push the appliance and fix it on
the cabinet with (3) 3/16x2 Flat head screws and
(3) 5x24x1T Washer. (Two for right and one for left)
10. Use (4)M4x8 round head screws to screws the collar
on the top of hood.
11. Install duct work and seal with aluminum
duct tape.
12. Remove the protective film from oil tray and
install it on the lower side of appliance.
14. Plug the appliance for a test run.
8. Use the two holes under backside to hang the
appliance on the installation bracket .
15. Turn on the light and you can open the
deflector panel.
When the panel is open, please take down the
baffle filters, and re-install the filters after remove
the protective film from those filters.
Installation Procedures
–
Under Cabinet
11
www.2pacific.com