Pacific Power Source LMX Series, Operation Manual

Page: 99 / 463

LMX SERIES™ OPERATION MANUAL
SECTION 6:
Front Panel Operation
Entire Contents Copyright

2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
LMX Series Power Source Operation Manual Page 99 of 463
6.4.8 STEP or RAMP Parameters
Step transients can be used to create discrete stair step like voltage and/or frequency
changes or smooth ramps. The default ramp time is 0.1 msec.
Ramps can be can be programmed in three modes:
• INIDEL (0): Initial & Delta: Programmed by initial and delta values
•
FINDEL (1): Final & Delta: Programmed by final and delta values
•
INIFIN (2): Initial & Final: Programmed by initial and final values
Step transients can be used to step frequency, AC voltage and phases.
The HOLD is ON, the last step values will be set as steady-state when the step execution
ends. Duration of each step is determined by: LENGTH = WIDTH + RAMP TIME
The following parameters are available in a STEP VALUES screen.
PARAMETER Range Unit Description
Program Mode Initial & Delta
Final & Delta
Initial & Final
- Program Entry Modes
Waveform 1 ~ 200 Waveform number
Voltage AC 1 0 ~ 135 Vrms AC Voltage
Frequency
15 ~ 5000 Hz Frequency
Table 6-14: Available STEP Transient Parameters
The following soft keys are available on the STEP PROGRAM screen.
SOFT KEY Description
(SK1)
Run Screen(SK2) Displays the STEP EXECUTION screen.
Phase ABC (SK3) Toggles between phase A, B, C or Coupled ABC
Example (SK4)
Displays a graphical representation of the STEP parameters
Back (SK5) Returns to previous screen
Table 6-15: Available STEP PROGRAM screen soft keys
Note 1: Depends on LMX model and T Option if any