Pacific Hoists U-MEGA PEH050, Operations Manual & Parts List

Page: 23 / 52

22
7.2 Troubleshooting and Remedial Action
SITUATION CAUSE REMEDY
Hoist will not
operate (1) Broken/disconnected
power or control circuit
wire.
(2) Low supply voltage
(3)
Motor hums but does not
rotate
(4)
Emergency stop button
release pushed
(5) Faulty contactor
Locate and repair/reconnect
Check if 10% reduction in voltage, have main
supply checked
Check phases to motor-insulate and repair
Check the cause as necessary
Operate manually if hoist runs then control
circuit/coil is faulty-locate fault and repair.
If hoist does not run then check main supply.
If input supply is correct but there is a faulty
output supply then replace the contactor
Hoist will not stop Welded contacts in contactor Replace contactor
Brake slips
Abrasion of motor brake Replace
Hoist runs but does
not lift (1) Clutch slipping Contact your authorized PACIFIC dealer –
this adjustment needs to be carried out on a
test rig
Abnormal sound on
load chain/chain
sprocket (2 falls) (1) Chain dry
(2) Worn chain sprocket (2
falls)
Lubricate
Replace load chain and chain sprocket
(2 falls)
Electric shock (1) Poor earth connection
(2) Accumulated foreign
matter/ moisture on
electrical parts
Provide correct earth connection
Remove foreign matter/dry electrical parts
Oil leak (1) No oil plug
(2) Loose fitting of oil plug
(3) No plug packing
(4) Worn or deteriorated Attach the normal oil plug
Fasten the plug tightly
Attach normal packing
Attach the new packing