Pacific Floorcare S-24, Manual

Page: 26 / 92

RETURN TO
TABLE OF
CONTENTS
- 21 -
SQUEEGEE SYSTEM
REMOVAL & INSTALLATION
SQUEEGEE USE
Squeegee Blades and system should be inspected and maintained regularly to achieve peak machine
performance.
Install : Align the slots in the squeegee assembly with the easy-grip knobs,
attach the vacuum hose, and tighten the knobs.
Remove : Loosen the easy-grip knobs, remove the vacuum hose, and
remove the assembly.
With the Key Switch turned on, lower the Squeegee Lift Lever to activate
the Vacuum Motor. Raising the Squeegee Lift Lever will deactivate the
Vacuum Motor to shut off after a 10 second delay. This delay ensures all of the
recovered water is pulled into the Recovery Tank.
SQUEEGEE ADJUSTMENT
Improper adjustment of the squeegee blades will reduce
the systems ability to properly pick up water. The leading
edge of the rear squeegee blade should contact the floor
at a 45° angle (similar to the image shown below). The
height of the squeegee system is adjusted using the two
cap head screws located next to the easy-grip knobs.
Raise (by turning the screws clockwise) or lower (by
turning the screws counter-clockwise) until the proper
blade deflection is achieved. When the system is adjusted
properly, the small gray wheels on the squeegee system
should be approximately 1/32” off of the floor.