Pacific Floorcare S-24, Manual

Page: 13 / 92

RETURN TO
TABLE OF
CONTENTS
- 8 -
BATTERYSHIELD
®
AUTOMATED WET BATTERY PROTECTION
SYSTEM
Machines equipped with BatteryShield
®
technology have a sensor installed on one of the battery caps and a red
LED indicator located on the Control Panel. This sensor monitors the water level in the batteries and the LED
communicates to the operator that the batteries require servicing. When the BatteryShield
®
LED is lit, the scrub
head is disabled until battery servicing has been performed.
• When the key switch is turned on, the BatteryShield
®
system will check the water level of the batteries.
• If the LED turns off, there is sufficient water in the batteries.
• If the LED remains on (without flashing), the batteries require servicing and the scrub head will not run.
• If the LED flashes intermittently, the BatteryShield
®
light pipe must be cleaned (instructions below).
NOTE
: Failure to clean the BatteryShield
®
light pipe will limit the system’s ability to read the water level and
will reduce battery life.
• If the BatteryShield
®
LED indicates the need for servicing, turn off the key switch and service the batteries
as described above.
• After completing the Hydrolink
®
watering system procedure, turn the key switch back on and verify the
LED turns off.