Pacific Floorcare S-24, Manual

Page: 10 / 92

RETURN TO
TABLE OF
CONTENTS
- 5 -
BATTERIES
SELECTION
INSTALLATION
WARNING: Battery posts, terminals, and related accessories contain lead and lead compounds, chemicals
known to the State of California to cause cancer and reproductive harm, and during charging,
strong inorganic acid mists containing sulfuric acid are involved, a chemical known to the
State of California to cause cancer. Wash hands after handling. For more information go to
www.P65Warnings.ca.gov .
WARNING : Batteries emit hydrogen and oxygen gas.
• Keep sparks and open flame away.
• Do not smoke near the machine
• Charge batteries in a well-ventilated area with the battery compartment open
WARNING : Do not wear jewelry when working near moving or electrical components.
CAUTION : Park and service the machine on a level surface and remove the key.
CAUTION : Always wear protective clothing, gloves and goggles when handling and charging batteries.
NOTE : All repairs must be performed by a qualified service technician using approved replacement parts.
NOTE : Failure to clean the BatteryShield
®
light pipe will limit the system’s ability to read the water level and
will reduce battery life.
NOTE : Batteries designed for automotive or marine and RV use are not suited for use in floor scrubbers.
1. Open the Recovery Tank.
2. Use a lifting device capable of lifting and transporting the batteries safely.
3. Move the batteries into position (as shown below).
4. Connect the batteries in a series to obtain an overall voltage of 24V.
5. Fully charge the batteries before use.
FRONT
The machine requires two 12 VDC Lead Acid or AGM Deep Cycle batteries designed for floor scrubber use
with the following maximum dimensions:
• Width: 7 1/8 in (181 mm)
• Length: 12 15/16 in (264 mm)
• Height: 10 5/8 in (295 mm)