SUMINSERTA 260407-20
7
Surround Assembly and Installation
1) Lay part A, B and C face down on a fl at non-marring
surface. Fasten together with 1/4" x 1/2" bolts and nuts
provided through holes at points “D” (Fig. #5 and 8).
2) Lift the surround assembly to the upright position and
make sure the front face is fl at and even at the joints.
3) Assemble the three trim pieces using the enclosed
hardware. Slide part F into the back corners of the
trim and tighten screws. Ensure the mitred corners fi t
tightly and evenly (Fig. #6).
4) Slide the assembled trim over the surround from the
top (Fig. #5).
5) Tighten the retaining screws at the bottom of each trim
side (Fig. #7).
Fig. # 5
Fig. # 6
Fig. # 8
Fig. # 9
6) On the stove, loosen the two bolts that fasten the ashlip
in place and remove. Place on a fl at, stable surface to
avoid damage (Fig. #9).
Part B
Trim
Fig. # 7
Trim
Retaining
Screw
Part F
Part A
Part C
Part A
Trim
D
D
D
1/4" Nuts
Part C
1/4" x 1/2" Long
Summary of Contents for SUMMIT WOOD INSERT DESIGN-A
Page 17: ...SUMINSERTA 260407 20 17 Fig 18...
