The blowers must be connected to 120 VAC house hold electrical system. Connect the blower circuit to a wall
switch or fan speed controller.(not supplied)
Insert the Romex 14/2 wire, or equivalent, into the unit through the cable clamp located on the right hand side
of the support base (Figure 18).
Connect the wiring as shown in the wiring diagram (Figure 19) to the wires located in the terminal strip.
All electrical connections should be performed by a certified/licensed electrician.
Convection Blower Wiring
Cable
Clamp
Wire
Terminal
Figure 18: FP30 Strain Relief.
Neutral
Line
Ground
Blowers
Temp
Switch
Junction Box
From Wall
Switch/Fan
controller
Electrical Rating : 115 V, 60 Hz, 1.1A
Figure 19: FP Wiring Diagraml.
23
100000811_200418-48
FP30 Series B
