Pacific energy FP25, Assembly, Installation And Operating Instructions, Page: 18 / 40

Item Part # Description Qty.
1 5049.9912 SCREW, TEKS
#8 x 1/2”(13mm)
Pkg 40
2 7746 STUD, TOP/BOTTOM
56”(1.42m)L 2
3 9093.22 STUD, CNTR
SUPPORT SIDES,
15”(381mm)L 5
4 7747 FRAMING KIT LEG 3
1/2"(89mm)L 3
Framing Kit Installation
Each Kit Contains:
Assembly
• Lay out top/bottom studs (#2) and center studs (#3) on
their sides on a large flat surface.
• Using the screws provided (1), attach the framing kit
legs(4) to the bottom stud (2).
• Next, attach each center support(3) to the bottom stud(2)
and then attach the top stud(2) to the center supports(3).
Installing the unit into the chase
• Push the Fireplace into place
(Casing must be flush with the
framing in the front) and secure if
required by local code.
• Place the Steel Framing Kit on
top of the unit with the legs down
(Figure 9). Ensure the front edge is
flush with the Fireplace and with the
chase framing. It is very important
to provide a flat surface to attach
the outer non-combustible board to.
• Attach the Framing kit securely to
the chase's framing using appropri-
ate fasteners.
2
4
1
1
Figure 8: Framing kit parts.
Figure 9: FP25 Chase with unit.
18
100001385_071118-40
FP25