6
7
Assembly
Follow the assembly steps in the
order listed below.
❶ Place the front wheel
between the fork and slide
the front axle through the
fork and front wheel. Insert
the washer over the end of
the axle and fasten the nut
until tight.
❷ Attach the right wheel
assembly to the rear axle.
❸ Cut the zip tie to remove
the gear box from the
scooter body. Insert
the gear box into the
rear gear wheel.
❹ Attach the left wheel
assembly to the rear
axle/gear box.
❺ Press the handlebar down
into the handlebar slot.
❻ Insert the tabs of the storage
compartment into the
storage compartment slots.
❼ Attach the sidecar scooter by
aligning the holes on the
sidecar bracket with the holes
on the scooter body. Insert
the two sidecar bolts into the
holes and fasten until tight.
❽ Insert the windshield tabs
down into the slots at the
front of the sidecar.
❾ Insert the tabs of the
sidecar backrest
into the slots at the
back of the sidecar.
❿ Charge the battery (see the
charge the battery image
on page 8).
⓫ Attach the seat and lock it
into place by tightening the
small screw on the back-end
of the seat.
❿
❽
❾
❹
❻
Charge the battery BEFORE
attaching the seat (see page 8).
❷
❺
❼
To tighten the wheel bolts, place a wrench
on each wheel bolt and simultaneously
turn the wrenches in the opposite
directions until the bolts are tight.
Make sure the front
fender is snapped
all the way in the
white brackets.
Insert the hubcap
tabs into the slots of
the hubcap insert.
❶
⓫
❸
