23
ADL Vantage/ADL Vantage Pro/ADL Vantage 35
Function
Description
Parameter choices
S Whitening
Only used in special circumstances
On (Non-standard)
OFF
For the field-configurable functions, the available choices are displayed on the bottom
row of the LCD. The currently selected parameter is marked with an asterisk. To select a
different choice for the displayed function, scroll up or down with the arrow buttons and
press
Enter
when the required choice is displayed.
There are two ways to move to a different function screen:
• When viewing a display-only function, such as Device Status or Signal Strength,
press the left or right arrow.
• When viewing a display-and-select function, such as Channel/Freq or Data
Protocol, press the up/down arrows to display the currently selected parameter
(marked with an asterisk) in the second row. Then press either the left or right
arrow to move to a new function screen.
Note – If the currently selected parameter (shown with an asterisk) is not currently
displayed on the LCD, and the backlight is off, you have not pressed a button for more
than 20 seconds, you can scroll directly to the selected parameter by pressing the left or
right arrow once. To move to a new function screen, press the left or right arrow a second
time.
To speed field configuration and to prevent the selection of unsupported radio
configurations, the user interface displays only those function settings that make sense
based on the settings chosen for previously displayed functions. What you choose
for the data protocol determines your options for radio link rate and repeater mode.
For example, if your channel table is set to 12.5 kHz channel spacing, and you select
TRIMTALK v1 on the Data Protocol screen, you cannot select a radio link rate (the Radio
Link Rate screen does not even appear) because the TRIMTALK v1 protocol works with
12.5 kHz channel spacing only at 4800 bps. And because TRIMTALK v1 is a Trimble
protocol, Trimble-specific “Operation Modes” (instead of “Repeater Modes”) are
available for selection. If you decide to undo any of these selections, press the left arrow
to return to the Data Protocol screen and then select a different protocol.
