10
8
5
11
12
A
B
B
#8 x 1.5" Pan Head (4 pcs)
HARDWARE NEEDED
ASSEMBLY INSTRUCTIONS (cont’d)
Step Five:
5-1. Route wire harness over the top of the right panel
support tube
f
and rest in front of the cross brace
as shown in the image below.
5-2.Route the Contact HR wires in front of the cross brace.
5-3. Lower control panel
l
onto the panel support tubes
f
and
i
.
Assembly with four #8 x 1.5” pan head screws tubes
m
. Start with the screws
labeled ‘A’ and then proceed to ‘B’.
Note:
Make sure you do not pinch the wire harness.
Wire Harness
Contact HR Wires
