4
TT-65
HANDPIECE SETUP
HANDPIECE ALIGNMENT
Check the handpiece heaters for proper alignment with each other. Proper
handpiece (and tip) alignment is essential for effective operation.
1. Remove any installed tip halves.
2.
With the handpiece at room
temperature
, adjust the Heaters parallel
to each other (see
Á
) using the Tip Gap
Adjustment Thumb Screw (item
À
). If
the heater ends are even with each other,
go to "Power Source Connection". If the
ends are not even, go to step 3.
3. Loosen the handpiece Hinge Screw (item
Â
) 1/2 turn.
4. Holding the handpiece in a vertical
position (heaters facing down), place the
ends of the two Heaters against a hard
flat surface to insure proper alignment.
The Heater ends should be even with
each other and flush against the flat
surface. Gently push the rear of the
handpiece handles to force both Heaters
against the flat surface.
5. Retighten Hinge Screw (item
Â
) to
secure in position.
