9
TT-65
TIP PREPARATION
Always follow the procedure below for each component removal operation and prior
to storage of the handpiece in the hot cubby. Proper preparation will insure optimum
results and increase tip life.
NOTE
The use of a PACE Tip Maintenance Station (P/N 6993-0138) is
recommended for the proper preparation and maintenance of all
ThermoTweez tips. If this item has not been purchased, contact your local
authorized PACE distributor for assistance.
1. Insure that the installed tip has reached the set tip temperature.
2. Use the fiber tool found in the Tip
Maintenance Station to remove all solder
dross and excess solder from the inside
edges of the tip. PACE recommends
placement of the tip over the moistened
sponge area of the Tip Maintenance
Station to catch solder and dross removed
from the tip.
3. Wipe the inside edges of the tip using the
sponge cleaning tool or the sponge area
of the Tip Maintenance Station.
NOTE
Insure that the sponge material is moist.
4. Use a large gauge solder to tin each of
the tip lower inside edges.
