Pace Sky digibox, User Manual

Page: 44 / 65

40 Using your Sky digibox
❖
Setting your remote control to operate
your TV
The Sky remote control can control both your Sky digibox and TV.
Your Sky remote control should have been set up to work with your
TV when your Sky digibox was installed.
If your Sky remote control is not correctly operating your TV, complete
the following steps.
Before you start, look up the four digit code for your brand of TV in
this list.
If your brand of TV is not shown here, refer to the Remote control setup
codes on page 54.
1. Turn your TV on.
2. Press tv on your Sky remote control.
3. Hold down select and the red key together for about two
seconds, until the red light on the Sky remote control blinks
twice.
4. Press tv on your Sky remote control again.
5. Key in the 4 digit code for your brand of TV. The light on the
Sky remote control should blink twice.
If the light blinks once only, recheck the code for your brand of TV and
start again at Step 1.
6. Press the standby key ( ) on your Sky remote control.
If your TV switches off, press select . The light on the Sky remote
control will blink twice.
If your TV does not switch off, press tv , then press the standby key
( ). Repeat this action until your TV turns off, then press select .
Brand Code Brand Code Brand Code
Akai 0098 Granada 0340 Panasonic 0051
Alba 0043 Grundig 0345 Philips 0081
Amstrad 0063 Hinari 0365 Saisho 0649
Bush 0157 Hitachi 0145 Samsung 0060
Decca 0244 JVC 0053 Sanyo 0159
Ferguson 0293 Matsui 0477 Sharp 0093
Fidelity 0294 Mitsubishi 0150 Sony 0000
Finlandia 0296 NEI 0514 Tatung 0049
Goodmans 0335 Nokia 0536 Toshiba 0156