MTS Systems Operation Manual
©2004 PACE Inc., Annapolis Junction, Maryland
Page 7 of 11
All Rights Reserved
HiFlo Vacuum Port
LoFlo Vacuum Port
If the power is turned on while a Power Module is not installed, or if the Power Module is removed
during operation, the system will turn itself off and the LED indicator light on the front panel will turn
red.
To operate the unit, please make sure the set-up procedure has been followed. Then follow the
procedure below.
1. If using the TD-100 handpiece, make sure the desired Tip Cartridge is installed. If using the
MT-100, make sure the desired pair of tips are installed.
2. Install the desired Power Module into the Power Port on the front of the unit that corresponds
to the appropriate handpiece channel.
3. The LED indicator will turn amber while the tip(s) is (are) heating to the desired performance
level.
4. Once the tip has reached the desired level, the LED indicator will turn green and the system
is ready to use.
To preserve tip life and save energy, MTS systems come standard with Auto-
Setback and Auto-Off Features. These are pre-
programmed for 30 minute Auto-Setback and 30 minute
Auto-Off, which can be turned off by the switch on the back
of the unit. If the handpiece channel has not been used for
30 minutes, the channel will enter setback mode, the
performance level will be adjusted to 3.5 and the LED will
blink amber. To exit Setback mode, place the tip in the
sponge to load it thermally or turn the Power Switch OFF
(“0”) and then back ON (“l”). After an additional 30 minute period of inactivity the channel will turn off
and the LED will turn off. To exit Auto-Off mode, cycle the system power. The Setback/Auto-Off
feature can be turned off for each channel individually. As received from the factory, this feature is
enabled.
Vacuum Pump Operation
The PACE MTS 300/350 contains two different vacuum
pumps.
1. HiFlo pump
a) To activate, depress the handpiece activation
button.
b) An Optional Foot Pedal can be used to actuate the
HiFo pump via the rear panel foot switch socket.
2. LoFlo Pump
a) This pump will be activated by a front panel
mounted Illuminated LoFlo Pump Switch.
b) Used for the TJ-80 and PV-65 Pic Vac Wand.
Setback/Auto-Off
Switches
AC Power
Receptacle/Fuse
Holder
HiFlo Pressure Port
LoFlo Pressure Port
Illuminated LoFlo Pump
Switch
MTS 350 Shown
