©2005 PACE Inc., Annapolis Junction, Maryland
Page 6 of 17
All Rights Reserved
6. Angle the power source so the operator can see the front panel easily and tighten the nuts
with a wrench or pliers.
Tip & Tool Stand
The Tip & Tool Stand can be set on a workbench unattached, or can be mounted to the power
source. If the HW 50 or TW 50 is to be mounted under the workbench or shelf using the optional
mounting bracket , the Tip & Tool Stand should not be mounted to the power source.
1. To attach the stand to the power source:
a) Insert the 2 large hex head Mounting Screws (head
first) into the lower “T” slot on the side of the power
source case as shown.
b) Place the Tip & Tool Stand beside the power source.
Insert ends of the 2 Mounting Screws into the 2 Tip &
Tool Stand mounting holes as shown.
c) Install a Thumb Nut onto the end of each Mounting
Screw and tighten Thumb Nuts.
d) If the Optional Instant Setback Cubby is purchased
(Part Number 6019-0071-P1), connect the Cubby connector plug into the
Instant Setback Cubby Receptacle in the following manner.
2. Place the handpiece into its Tip & Tool Stand.
Adjusting the Angle of the Cubby
The angle of the standard Handpiece Cubby may be adjusted by loosening the
angle thumb screw slightly, adjusting the cubby to the desired angle, and
tightening the thumb screw. If the instant setback cubby was selected the cubby
angle is not adjustable.
Handpiece Connection
Connect the handpiece connector plug into the Power Receptacle in the
following manner.
NOTE:
Only connect the handpieces with the red connectors to
the HW 50 and TW 50.
1. Align guide on the connector with slot on power receptacle.
2. Insert connector into power receptacle.
3. Turn the connector housing clockwise to lock in place.
System Power Up
1. Insert the female end of the power cord into the AC Power Receptacle on the rear panel of
the power source.
2. Plug the prong end (male end) of the power cord into an appropriate 3 wire grounded AC
supply receptacle.
CAUTION:
To insure operator and ESD/EOS safety, the AC power supply receptacle must be
checked for proper grounding before initial operation.
NOTE:
Ensure that the system is placed in a well-ventilated area. Fume extraction equipment
is recommended
Thumb Screw
Instant Setback Cubby
Receptacle
