Reel-Out.
The winch drum will pay-out
cable. Cable speed is proportional to
joystick position. When released, the
handle will return to neutral and the
winch drum will stop and hold the load.
Drum clutch release.
This position will
release the drum clutch and permit the
operator to drive away from a load. The
resistance of the gear train will keep a
tight wrap of cable on the drum to prevent overrun. It
should be noted that the resistance of the gear train will
not permit cable to be pulled off the drum by hand. The
joystick will stay in the detented, clutch released position
to permit the operator to use both hands for tractor oper-
ation. Lightly pull the lever back toward the operator to
release the detent and apply the drum clutch.
Low-Lock/Auto-Speed.
Press one
side of the rocker switch on top of
the lever to apply low-lock (indicator
light on) which will hold the variable
displacement motor in the maxi-
mum displacement position for
maximum line pull and minimum line speed to enhance
precise load control. Press either side of the rocker
switch to return to full auto-speed operation (indicator
light off) where the motor displacement will self adjust
between the maximum and factory-set minimum dis-
placement to achieve the best match of line speed and
line pull for the application.
Winch disable.
Pull and move switch to
disable winch operation. Leave switch in
disable position when winch is not being
used.
DO NOT use drum clutch release for controlled reel-
out of suspended loads. Sudden release of load may
result in property damage, injury or death. Use only
reel-out to lower loads.
CAUTION
WARNING
!
!
The H90VS hydraulic motor and gear ratio is config-
ured to match the hydraulic system od a specific trac-
tor. It may not be possible to mount the winch onto a
different model tractor. Installation onto a tractor with
a higher flow hydraulic system could result in over-
speed damage to the motor and winch gear train.
The maximum drum RPM in auto-speed no-load, with
a piston motor, is listed below:
H90VS - 211XXXX 22 to 24 RPM
H90VS - 254XXXX 18 to 20 RPM
CAUTION
5
Summary of Contents for CARCO H90VS
Page 2: ......
