23
2. Turn the assembly over and install the sprag clutch
in the bore of the outer race.
3. Press the remaining bushing into the race. Again,
make sure the bushing is against the shoulder.
4. Next, install a sprag bushing retainer, then a snap
ring on the inner race. Be sure the snap ring is
seated in the snap ring groove.
5. Slide the inner race through the bushings and sprag
clutch (the race will have to be rotated in the free-
wheeling direction to start it through the sprag
clutch). If the inner race will not go through the
bushings, the bushings have probably been dam-
aged and should be replaced.
6. Turn the assembly over with the snap ring down.
Install the second retainer and snap ring. Make cer-
tain the snap ring is seated in the groove properly.
7. This is a completed brake clutch assembly.
ARN-
ING
Be certain the snap ring is seated in the groove in the
splined bore of the inner race. This snap ring will
keep the brake clutch assembly correctly positioned
in the center of the friction brake pack. Binding of the
brake or brake failure may occur if this snap ring is
omitted.