29
PLANET CARRIER SERVICE
OUTPUT PLANET CARRIER
DISASSEMBLY
1. Remove the planet gears by driving the roll pins into
the center of the planet shafts.
2. Use a punch to drive the roll pins from the planet shafts.
Do not reuse the roll pins.
3. Now you can remove the planet shafts, bearings,
spacer, thrust washers and gears. Thoroughly clean all
parts and inspect for damage and wear. The bearing
rollers should not exhibit any irregularities. If the roll-
ers show any sign of spalling, corrosion, discoloration,
material displacement or abnormal wear, the bearing
should be replaced. Likewise, the cage should be in-
spected for unusual wear or deformation, particularly
the cage bars. If there is any damage that will impair
the cage’s ability to separate, retain and guide the
rollers properly, the bearing should be replaced. The
thrust washer contact areas should be free from any
surface irregularities that may cause abrasions or fric-
tion. The gears and shafts should be inspected for ab-
normal wear or pitting. Replace if necessary.
ASSEMBLY
1. Place the output planet carrier on workbench with
splined coupling side down. Install output thrust plate
in center of carrier.
Summary of Contents for Braden BA2A
Page 2: ...2...
Page 25: ...25 THIS PAGE INTENTIONALLY LEFT BLANK...
Page 26: ...26 WINCH CROSS SECTION...