Single Channel Wireless Air Spring Controls
L6597
5
1 FIND A SUITABLE MOUNTING LOCATION
The single channel wireless air control kit is designed to be versatile with a universal mounting style.
The kit features an air compressor assembly and controller which can be mounted in any location by drilling holes and
securing with the provided hardware. The air compressor can be mounted in any orientation, and various size air compressors
are available to suit various power needs and space limitations.
PLEASE NOTE: The compressor assembly and controller must be mounted within 24” of each other due to pre-assembled
harness length. If required, harness can be extended. Ensure to use matching wire type, wire size and sealed connections.
Do NOT mount controller or compressor assembly directly on engine or other components exhibiting harsh vibration
Do NOT mount the controller or compressor assembly in areas where ambient temperature exceeds 70°C [158°F]
Determine a suitable mounting location for the kit with the following requirements:
• Mounting surface must be rigid.
• Location should protect the kit components from debris and
excessive moisture.
• Kit must not interfere with surrounding components during vehicle
operation.
• Surrounding area must have adequate clearance to route the
wiring harness and air lines without causing sharp bends
Possible kit mounting locations can include:
• Along the frame rail (as shown in Figure 1)
• Inside the engine bay
• Inside the truck bed
This manual is used across multiple kits - please pay close attention to important warnings listed below for a safe installation.
BEFORE STARTING THE INSTALLATION:
1.
Read through this manual and ensure you can complete the installation once started.
2.
Ensure the kit you received contains all the items shown in the Kit Contents on Page 2.
3.
It is recommended to use a good quality anti-seize on all fasteners. This will reduce the chance of corrosion on the fasteners
and will help facilitate removal, if required at a later date.
PLEASE NOTE:
Using scissors or wire cutters to cut the nylon airline will distort the line and cause the connection to leak. THE AIRLINE MUST
BE CUT OFF SQUARELY WITH THE NYLON HOSE CUTTER OR A SHARP UTILITY KNIFE.
1