�
�
�
�
�
SWI-X
Wiring Connections (cont.)
Step 4
If necessary
, perform the following operations as indicated by the notes in
Appendix E - Identification and Connection Chart
(pages 6-7)
. If no connections are necessary, proceed to Step 5.
Step 4a.
If necessary
, connect
the BLUE serial data
wire.
Connect this wire
ONLY
on GM pas-
senger vehicles (no
trucks or SUVs) with
airbags AND steering
wheel heater controls.
For all other vehicles,
cut and insulate the
BLUE wire.
Step 4b.
If necessary, cut the
BROWN wire loop and
insulate both halves.
Step 4c.
If necessary, either
cut the VIOLET wire
loop and insulate both
halves, or place a re-
sistor in-line if directed.
Programming the SWI-X to Work With the Vehicle
IMPORTANT!
Some steps of the programming instructions
must be completed within a certain number of seconds following the
previous step.
Review the complete instruction before beginning the programming sequence.
Step 5.
Refer to
Appendix C - Head Units That Require IR Extended Mode On (page 5)
and
Appendix E - Identification and Connection
Chart (pages 6-7)
. Note the
IR Extended Mode Setting
and
Version Number
next to the selected vehicle. Fill in the information below
for quick reference.
IR Extended Mode Setting:
____________
Version Number:
____________
Step 6.
Press and hold programming/
mode button on SWI-X. Turn the
vehicle ignition to the ON position.
Both LEDs on SWI-X
will light.
Step 7.
Release the programming/
mode button.
Both LEDs will turn
off, indicating memory
is cleared, then turn
on again
for only 3
seconds
.
Step 8.
To turn IR Extended Mode ON:
Press and release the program-
ming button
within 3 seconds
.
To leave IR Extended Mode OFF:
Do nothing for 3 seconds.
Note:
To change IR Extended Mode later, restart procedure at Step 6.
Steps 11-24 (learning radio commands) must also be repeated.
Both LEDs will turn off.
Step 9.
Press and release the
programming/mode button the
same number of times as the
desired version number.
LEDs will flash each
time the button is
pressed.
After 3 seconds
, LEDs
will flash to indicate set
version number.
Left LED: 10’s place
Right LED: 1’s place
Step 10.
Turn vehicle ignition
to OFF position.
Programming
sequence is complete.
SWI-X
OFF
ACC
IGN
STRT
SWI-X
SWI-X
SWI-X
SWI-X
OFF
ACC
IGN
STRT
�
�
�
�
�
�
�
�
�
�