Stinger HEIGH10
Radio Replacement Kit
for 2016-2021 Toyota Tacoma
SR-TAC16H
© 2021 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global. PAC-audio.com
Pacific Accessory Corporation
Page 8
Rev: V1
Date:122121
®
®
Section 3:
In-Vehicle Connections and Radio Unit Installation
Step 2
Connect the BAA44 antennna
adapter to the vehicle’s antenna
connector.
Step 1
Step 4
Connect the three or four vehicle
side connectors on the main
harness to the vehicle’s radio
plugs.
These are the connections for the basic installation. If adding additional components
such as a second USB, SXM tuner or additional cameras, those connections should be
made at this point, before mounting the radio module.
With the two display cables
routed over the top of the radio
assembly, slide the assembly into
position and re-install the four
factory 10mm bolts.
Step 3
Step 5
Plug in the GPS (1) and USB (2)
adapters. Note: The USB cable
must be plugged into the USB port
closest to edge of the radio chassis
for Apple CarPlay and Android Auto.
Plug in the 8-pin and LVDS display
cables into the back of the display.
1
2
X
Step 6
Re-install the factory radio/air vent
panel by aligning the retaining
clips and pushing until all the clips
engage.