Stinger HEIGH10
Radio Replacement Kit
for 2016-2021 Toyota Tacoma
SR-TAC16H
© 2021 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global. PAC-audio.com
Pacific Accessory Corporation
Page 3
Rev: V1
Date:122121
®
®
Section 1: Disassembly
Section 2: In-Vehicle Harness Preparation
This installation manual will cover the necessary order of procedures to complete the installation
efficiently and to avoid redoing any steps. The order will be as follows; Disassembly, In-Vehicle Harness
Connections, Display Mounting Panel Preparation, Radio Module Preparation, Interface and Main
Harness Connections, In-Vehicle Connections and Radio Unit Installation.
The installation steps shown are all required for full functionality of the radio. If adding additional
components; cameras, amplifiers, satellite radio, etc., additional steps and harnesses will be needed.
Before removing the factory radio, ensure that all vehicle settings that are
programmed using the factory radio are set to the desired settings.
Step 3
Step 2
Step 1
Remove all connectors and cables
from the back of the radio.
Remove the four 10mm bolts
securing the radio. Remove the
radio from the sub-dash.
Using your hands or soft tool, pull
and remove the radio trim and air
vent panel.
Step 3
Step 2
Step 1
Connect the adapters to the matching
colored connectors removed from the
factory radio.
From the SR-TAC16H kit, locate
the correct USB adapter
:
2016-2018 uses
USB-TY1
2019-2021 uses
USB-TY3
From the SR-TAC16H kit, locate
the GPS Antenna Adapter and
Satellite Antenna Adapter if
installing a SXM tuner.
USB
GPS
SXM
GPS-03
USB-TY1
USB-TY3
SAT-01
OR