Radio Replacement and Steering Wheel Control
Interface for Select Nissan Vehicles
RP4-NI13
© 2022 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global.
PAC-audio.com
Pacific Accessory Corporation
Page 1
Rev: 1
Date: 9/14/2022
Introduction and Features
Important Notes
Wiring Connection Chart
Illustration / Schematic
1. These instructions apply to R.1.5.1.4 or later revisions. The revision info can be found on a small white sticker on the interface
and packaging.
2. The radio select rotary switch on the side of the interface, must be adjusted to the proper radio setting before plugging the
interface into the vehicle (see next page for setting chart).
3. The interface comes pre-programmed for all of the vehicle’s factory SWC functions, and does not require programming unless
you wish to re-assign the SWC functions, or utilize short press, long press dual command functionality. The SWC can always
be restored to default settings by pressing and releasing the program button on the side of the interface once, and waiting 7
seconds for the LED to flash 4 times.
4. Does not retain 360 camera system.
SWC Connection
See above chart for
different radio type
connections
x4
Acc On/
Programming
LED
Programming
Button
Wiring
SWC Connection
The RP4-NI13 interface allows the replacement of a factory radio in select Nissan vehicles with MSCAN databus radios.
Using this interface will retain factory features, such as steering wheel controls (SWC), reverse camera, and the factory
amplifier, when the original radio is removed. Use of this interface also allows you to program two radio functions to
each SWC button by using short press, long press dual command functionality. The RP4-NI13 also provides outputs
such as vehicle speed sensor (VSS), illumination and *reverse trigger.
Vehicle Connector
SWC Connector
Yellow
B12v
Black
Ground
Red
Accessory 12v+
(10 amp)
Pink
Vehicle Speed
Output
Blue / White
Amp Turn On Input
Orange / White
Illumination Output
(+)
Purple / White *Reverse Output (+)
White
Front L + input
White / Black
Front L - input
Gray
Front R + input
Gray / Black
Front R - input
Green
Rear L + input
Green / Black
Rear L - input
Purple
Rear R + input
Purple / Black
Rear R - input
Yellow RCA
*Reverse Camera
Output
Blu/Yel
Kenwood, Newer
JVC
3.5mm Jack
Alpine, JVC,
Clarion, Fusion,
Pioneer, Sony,
Boyo, Dual,
Lightning Audio,
Visteon or Advent
* Only available in vehicles equipped with a factory reverse camera.
Cut for Non-Bose systems
Aftermarket Radio Connections
See above chart for wire color
description.
