PAC BCI-CH41 Quick Start Manual Download Page 2

Rev. 022615

Page 2

BCI-CH41

Navigation Unlock & Reverse Camera Input

 Interface for Chrysler/Dodge/Jeep/Ram Vehicles

Pacific Accessory Corporation

In these vehicles the BCI-CH41 only offers reverse camera input and viewing of the reverse 

camera at any time. Once installed, the reverse camera feature will automatically be activated. 

This means that whenever the vehicle is placed into reverse, the reverse camera input will 

automatically engage on the screen.

You can also force the reverse camera image at any time by pressing and holding the “Back” 

button on the SWC (see Fig. A) for 4 seconds until “Rev Camera On” is displayed on the 

MFD. 

Operation - RAM 1500, 2500 & 3500 with uConnect5 without audio SWC

Fig. A

To Access the Settings Menu

1. Place the MFD into the mode that displays the radios text.

2. Press and hold the “VR” button on the SWC for approximately 8 seconds (see Fig. B)

3. “BCI Menu” will be displayed on the MFD in the gauge cluster.

4. Use the Left/Right buttons on the front of the steering wheel (Fig. C) to scroll through and

make selections in the menus. Press the “OK” button to turn things on/off.

5. The list of available options are:

A.  Nav Unlock - This allows features that are normally blocked while the vehicle is in motion

to be unlocked.

B.  Remote Start Restore Climate Settings - restores the climate controls to the last known

setting on remote start. Without this feature the climate controls do not go to last known 

setting until a door is opened.

C.  Vid in Aux - This will automatically switch to the reverse camera whenever the radio is put 

into Aux mode and an Aux cable is connected. (Nav Unlock 

MUST

 be activated)

D.  12v in rev/12v in AUX/12v in Acc - This sets the interfaces red output wire behavior to 

trigger either a reverse camera, a video switcher or be an ACC output whenever the 

vehicle is on. 

E.  Exit Menu - Saves all settings and exits the menu.

In these vehicles the BCI-CH41 offers even more features. All of these features can be turned on/off through a menu accessible 

through the SWC. The BCI-CH41 comes with all features except reverse camera input set to off by default (except Cherokee).

Operation - 200 and Cherokee without audio SWC

To Activate the Nav Unlock feature

1. Press and hold the “OK” button on the steering wheel for at least four seconds, then release.
2. The MFD in the cluster will display “Confirm Safe Passenger Use”.
3. Once the text is finished scrolling, press the same button again within 5 seconds to acknowledge “safe use”, 

agreeing that

use will be performed only by the passenger whenever the vehicle is in motion

, and activate the BCI-CH41.

The MFD will display “Acknowledged”. The Nav Unlock feature is now active.

4. To de-activate the BCI-CH41 simply press and hold the “OK” button for at least four seconds and then release.
5. The MFD will display “NU Deactivated” The Nav Unlock feature is now deactivated.
You can also force the reverse camera image at any time by pressing and holding the left arrow button on the steering wheel for 4 

seconds until “Rev Camera On” is displayed on the MFD. If the MFD in not in the Radio text screen using the left and right buttons 

could cause you to change options through the display.

6. Once finished, scroll to the “Exit Menu” section and press the “OK” button or wait 30 seconds for the menu to timeout.

Fig. C

Fig. B

Reviews: