How To Remove a Readout
TO REMOVE AN UNWANTED READOUT
1- While gauge is running in gauge mode, TAP the right button to cycle to the readout you
would like to remove.
2- HOLD the left button until you see "- - - -" (while holding the left button you will see the bar
graph scroll back and forth across the screen)
The reading is now removed until you restore it. (see instructions below)
How To Restore Removed Readouts
TO RESTORE A REMOVED SETTING
1- HOLD both buttons until "ConF" appears and then release.
2- TAP the right button until you see "cc.x" ("x" being a placeholder for several different
options) You can find the correct cc setting for your car in the configuration chart above.
3- TAP the left button to cycle through the cc options and stop once you get to the correct
setting for your vehicle. (perform this step even if the cc setting is already correctly set for your
vehicle)
4- Once you are back to your correct cc setting HOLD the right button until the screen turns off.
(this saves/exits the menu)
5- Start your engine (if not already running) and the gauge will turn on. (It will take a little
longer than usual on the first startup after completing these steps)
This process forces the gauge to "re-scan" the ECU and pull all the readings that it can. All your
readings should be restored at this point.
PEAK RECALL:
The gauge offers peak recall of the PEAK VALUE on the selected mode, since the last recall, or
since the vehicle was started. In addition to this, for 2008+ model year cars the gauge also
stores peaks for EgT, Air, Coolant in the background, so that you can switch to that mode later,
after a lap for example, and recall your peak temperatures. A quick tap of the left button will
show your peak value.
Code Reading / Code Clearing
CODE READING: Code reading is performed automatically on startup. You can also read codes
on the fly by following the steps below -
Summary of Contents for V3
Page 12: ......
