Feature Locations
ON
OFF
Max.Amps
Volt/Amp
Watt/PF
KWH/Leakage
Elapsed Time
10 Normal Outlets
NFB Short Breaker
Display Panel
Surge
OK
Abnormal
Voltage
Volt
Watt
KWH
Amp
mA
%
Day
Hour
Wiring
OK
MAX
REPLACE
Over Load
MIN
NO Load
Over
Current
Ground
OK
Over current
No Appliance connected
Power Factor
Elapsed Days
Kilo - Watt - Hour
AC Power
AC Voltage
Line
、
Neutral Wired Correct
Grounded Correct
Surge Protection Ready
Up to date Max.
Out of Range Voltage
Defect Detect
Elapsed Hours
Leakage Current
AC Current
Up to date Min.
Over 15A Max Current
Quick Start Guide:
Use these quick start instructions to get up and running in just a few minutes. Be sure to review all the operating
instructions later to ensure full enjoyment of the product.
1. Connect the Kill A Watt
™
PS
unit to the outlet and the appliance to the unit.
2. The LCD display will flash. Press any of the function keys to stop the flashing.
3. Press the OFF key. The OFF key will illuminate red.
4. Press the ON key. The ON key will illuminate green and the attached appliance will be powered.
5. If the attached appliance is turned off and is not consuming any power, the unit will detect no load. The
ON key will go dark and the “NO Load” icon will flash on the LCD display. THIS IS NORMAL. If the
attached appliance is
then turned on, the unit will detect a load, the ON key will illuminate and the “NO
Load” indicator on the LCD display will disappear.
6. Pressing the Volt/Amp key will cycle through currently measured voltage (Volts), current (Amps) and
Maximum/Minimum measured values.
Shop for P3 products online at:
1.877.766.5412
www.
PowerMeterStore
.ca
