P1PE P5200BC, User Manual, Page: 11 / 32

11
(1)
(3)
(4)
(2)
INSTALLING THE TRIMMER HEAD
3.8 Place the collar ring (3) on the shaft thread (2).
3.9 Insert the allen key provided (1) into the gear case locking hole.
3.10 Screw the nylon spool (4) onto the shaft thread if the spool is threaded.
If the spool does not have a threaded centre hole, use the nylon nut and tighten
securely (you will have to remove the spool from spool housing).
3.11 Check the spool is secured tightly.
3.12 Before using the trimmer head. Mount the trimming knife with the 3 screws provided
onto the guard as illustrated below.
The trimming knife will cut and keep the trimmer line at the correct length.
Trimming Knife
3.13 Connect the lower shaft attachment to the main shaft ensuring it is fully engaged
and secure using main shaft bolt.
NOTE
Premature wear can take place if this connector is not tightened properly.