![P1PE P1000i User Manual Download Page 16](http://html1.mh-extra.com/html/p1pe/p1000i/p1000i_user-manual_3091201016.webp)
16
5.18
Before connecting the charger to a battery that is installed in a vehicle, the negative
battery cable must be disconnected first.
This will prevent sparks or a short circuit if the cable accidentally contacts the
vehicles body.
5.19
DO NOT
start the vehicle with the battery charger connected to the battery,
otherwise the generator will be damaged.
5.20
A battery can release explosive gasses.
Keep the battery away from any sources of ignition.
5.21
Charge the battery in a well ventilated area.
5.22
Battery electrolyte contains sulphuric acid that can cause severe burns to the skin or
eyes.
The correct Personal Protective Equipment (PPE)
MUST
be worn when handling
batteries.
5.23
If battery electrolyte gets on to the skin or eyes, rinse thoroughly with warm water for
at least 15 minutes and call a Doctor immediately.
5.24
If you swallow any battery electrolyte, rinse your mouth with water and drink plenty of
water or milk (with magnesia or vegetable oil) and call a Doctor immediately.
5.25
The DC socket can be used while the AC socket is in use.
5.26
If you use both at the same time, be sure not to exceed the total power for AC & DC.
The total power for AC and DC (AC:0.9kVA, DC:5A).
5.27
If the DC circuit overloads it will trip the DC circuit protector.
To reset, remove the load first and then reset the trip switch after a few minutes.
DC CIRCUIT PROTECTOR ON OFF