19
MAINTENANCE
Checking Spark Plug
•
Disconnect the spark plug wire from the spark plug.
•
Before removing the spark plug, clean the area around its base to prevent debris from entering the engine.
•
Clean carbon deposits off the electrode with a wire brush.
•
Check the electrode gap and slowly adjust to 0.80mm (0.031in.) if necessary.
•
Reinstall spark plug and tighten to Torque 22.0 – 26.9 Nm (16-20 ft-lb).
•
Reconnect spark plug wire.
•
If spark plug is worn replace only with an equivalent replacement part. Spark plug should be replaced annually.
Repairing Leaking Connections
•
Purchase O-Ring / Maintenance kits through the nearest authorized service center and follow instructions provided with
kit.
Air Filter
Storing Pressure Washer
If storing pressure washer for 30 days or more follow the procedures below:
•
Add fuel stabilizer to gasoline to keep gasoline from going stale and to prevent gum deposits from forming on the
carburetor. Run engine for a couple of minutes to circulate the fuel stabilizer.
•
Add PumpSaver to protect pump from freezing or damage caused by mineral deposits.
•
•
Disconnect the spark plug wire and clean the spark plug. Leave spark plug wire disconnected.
•
•
Cover unit with a suitable protective cover to keep unit dry.
•
Store unit in a frost-free area.
WARNING!
.
•
•
•
•
.
WARNING!
Water pressure produced by this unit can cut through skin and tissue leading to serious
injury and possible amputation.
•
Never attempt to repair high pressure hose, always replace.
•
Never attempt to repair leaks with sealant, always replace O-ring or seal.
Summary of Contents for P3500PWA
