P1 P3500PWA, User Manual

Page: 10 / 28

1
0
ASSEMBLY
Attaching Foot Assembly (See fig 1)
• Parts needed - 1 foot, 1 M8 lock nuts.
• Raise or tilt pressure washer so you can line up foot with the hole located at the centre of the frame.
• Align the rubber foot with the hole in the frame where the foot is to be located. Attach foot by inserting the bolt from the
bottom up and install the acorn nut. Wrench tighten until there is a slight crush on the frame tube. (Do not over tighten)
Install Handle (See fig 2)
• Install upper frame (handle) onto the lower frame by sliding the handle over the two upright tubes on the lower frame
and pressing down firmly until the handle is seated and the two detent pins snap in place.
Attaching Upper and Lower Gun Hooks (See fig 3)
•
Align the gun stock with the armrest hole,then connect gun stock and panel with bolts,finally Install another gun
stock hole with an expansion screw
.
FIG 3
FIG 2 FIG 1