Section 1 - TireView
™
TPMS Instruction Manual
Figure 5: Recommended Sensor Position for Automatic Code Learning
3.
The display will capture the sensor code and show it on the screen. Push and release the
SET
button to
save the code to that tire position. When coded correctly, a unique six-digit code will be shown.
4.
Use the
+
button to move to the next tire position to be programmed. Push and release the
SET
button
and
FFF FFF
will flash. Place the sensor for that tire position at the bottom of the display and press the
GO
button to capture the sensor code. See
SET
again to save. Continue this process for each
tire position/sensor.
5.
When all the sensors have been coded, pressing the
BACK
button twice will take you to the main screen.
Note:
The sensors will begin reading "0" pressure and an alarm will sound. This is part of the normal setup
process. Press any button to silience the alarm while you continue your setup.
Pressure Code Learning (option #2)
1.
Screw the sensors partly onto each designated valve stem. Do NOT screw them down far enough to hear
air escaping out.
2.
Push and hold the
SET
button until it beeps. The
HI PRESSURE SET
parameter will blink at the bottom of
the screen. Push the
+
button and scroll through the parameters until
LEARN ID
appears.
3.
Quickly push and release the
SET
button. The first tire on the display will blink. If programing a different
tire, press the
+
button to move to the correct tire. Push the
SET
button again and
FFF FFF
will flash.
4.
Tighten the sensor down on the corresponding tire valve stem. The sensor code will display and flash.
5.
The display will capture the sensor code and show it on the screen. Push and release the
SET
button to
save the code to that tire position. When coded correctly, a six-digit unique code will be shown.
6.
To remove the sensor code, push
BACK
once.
FFF FFF
will reappear.
7.
When all the sensors have been coded, pressing the
BACK
button twice will take you to the main screen.
Manual Coding (option #3)
Note:
This method is mainly used to program sensor codes from an old display to a new display if you do not have
the sensors available. This method is not recommended for programming a new system.
© Pressure Systems International Inc.
All rights reserved worldwide.
18
T004-01 Rev 06-19