www.EasyAssemblyRequired.com
INSTALLATION INSTRUCTIONS
I NSTR UC TI O NS PER TAI NI NG TO A R I SK O F FI R E, O R I NJUR Y
TO PER SO NS I MPO R TANT SAFETY I NSTR UC TI O NS
INS T ALLAT IO N GUIDE LINE S
Save these instructions!
Professional
Series
CS933
-LED
Well Lights
For use with Low Voltage Landscape Lighting Power Units. FOR OUTDOOR USE ONLY.
Amperage not to exceed 25 AMPS ‐ Voltage not to exceed 15 VOLTS
Warning:
Luminaire must be installed in accordance with the National Electric Code (NEC) and all Local Codes. Failure
to comply with NEC and/or Local Codes may cause serious injury and could destroy the luminaire. Failure to comply
with NEC and Local Codes will void all warranties.
•
Low voltage cable shall be protected by routing in close proximity to the luminaire or fitting, or next to a
building structure such as a house or deck and have the length cut off so that it is connected to a connector
within 6 inches (15.2 cm) from a building structure, a luminaire, or fitting.
•
When ordering additional wire or cable, please contact the manufacturer customer service or contact a
qualified electrician.
Safety Warning:
LAMP IS HOT WHEN LUMINAIRE IS ON! Hot lamp creates risk of fire and injury to persons. Keep away
from combustibles. Lamp gets hot very quickly. Turn off or unplug luminaire and allow lamp to cool to change bulb.
When using high wattage lamps, keep luminaire away from children, as luminaire may become VERY HOT. Do not
install luminaire within 10 feet (3.05 meters) of a pool, spa, fountain, or pond. Do not bury luminaire below the
recommended depth and keep luminaire clear of debris. Use only UL compliant components including low‐voltage
power units, cable, wire connectors, and any other component necessary.
CAUTION: Luminaire is NOT submersible!
NOTE: Do not exceed the maximum wattage rating or maximum amperage rating of the power unit (transformer)
used when installing multiple luminaires. NOT FOR USE WITH DIMMERS!
1.
Disconnect or unplug transformer from power source.
2.
Dig a hole at the location desired 6” in diameter and
approximately 12” deep.
3.
Add 7” of gravel in the bottom of the hole for drainage.
4.
Connect the wire terminals to the main lead to the
transformer using included Quick Connect lead connectors.
5.
Cable may be buried if desired to a maximum depth of 6
inches underground.
6.
Adjust angle of bulb and tighten wing nuts on side of
luminaire to secure position.
7.
Do not exceed 12 Volts at the Luminaire.
8.
Recommended Lamp:
9
W Par36
LED
CAUTION: POSITION LAMP TO ENSURE BULB DOES NOT TOUCH
LENS COVER TO AVOID DAMAGE. KEEP LENS CLEAR OF MULCH
AND DEBRIS AT ALL TIMES!
pg.
4
