www.pmlighting.com
To clarify installation and wiring of your 100 watt Professional Series power transformer, please refer to
the instructions below.
1) USE ONLY THE BOTTOM SCREW TERMINALS TO ATTACH THE MAIN CABLES FROM THE LIGHT FIXTURE
RUNS.
DO NOT LOOSEN TOP SCREWS OR REMOVE WIRES ATTACHED TO THE TOP SCREWS
.
2)
EACH MAIN CABLE RUN MUST BE CONNECTED TO 1 (LEFT) AND 2 (RIGHT).
SEE DIAGRAM BELOW
(SHOWING UP TO 2 MAIN CABLE RUNS).
3) ATTACH ONE SIDE OF THE MAIN CABLE RUN TO THE LEFT TERMINAL (1) BY INSERTING THE STRIPPED
WIRE (APPROX. ¾”) INTO THE BOTTOM OF THE TERMINAL BLOCK. ATTACH THE OTHER SIDE OF THE
MAIN CABLE RUN TO THE RIGHT TERMINAL (2). TIGHTEN BOTTOM TERMINAL SCREWS TO SECURE EACH
WIRE.
CS8100 Professional
Series
Landscape Lighting System
–
pg. 8
Transformer Terminal Block
Insert one side of each main cable run into the bottom of the terminal block
in the (1) LEFT screw terminal and one side in the (2) RIGHT screw terminal.
CAUTION:
DO NOT LOOSEN TOP
SCREWS OR REMOVE ANY WIRES IN
TOP PORTION OF TERMINAL BLOCK!
1L
2R
