4
MAN 9063181 EN V1
P. Lindberg A/S
Sdr. Ringvej 1
www.p-lindberg.dk
Tel.: +45 70212626
6600 Vejen, Denmark
E-mail: [email protected]
Setting the torque
1.
Pull the bottom out of the handle.
2.
Turn the handle clockwise to increase the torque setting. When setting the torque, always set to a
higher setting. If the wrench has been set to a torque setting that is greater than the desired
setting, turn down the torque to one revolution below the desired torque and then turn up to the
desired torque.
3.
The two large scales show the torque setting in both the primary and secondary units. The smaller
scale shows the fine increases in the primary units. See the examples below.
4.
Press the bottom in to lock the handle. The smaller scale can be slightly offset in relation to the
centreline mark without this affecting the settings' precision.
Examples of torque settings
Unlock
Set the torque
Lock
