P.I.T. GHO110-C, User Manual

Page: 6 / 20

4
ELECTRIC PLANER
1. Binding screw for horizontal limit stop 9. Belt guard
2. Planing depth regulator 10. Safety stop
3. Additional handle 11. Rear column
4. On/off control 12. Base
5. Power lock button 13. Front pillar
6. Hole for horizontal limit stop mounting 14. Lock screw
7. Protective cover 15. Fly screw
8. Chip ejection tube
RULES OF OPERATION
Assembly
Install (if necessary) a horizontal limit stop: insert the stop rod into the hole (6) on the desired side of the planer,
adjust its reach according to the workpiece and fix it with a screw (1). Install the chip ejection tube (8) on the
required side of the planer: drown the tube retention pin and pull it out of the case. By turning 180 degrees, sink in
the retention pin and fully set down into the case, aligning the alignment slots. If necessary, install the attached dust
collection bag or vacuum cleaner hose onto it. Depending on your vacuum cleaner model, an adapter may be needed
(not included).
Assembly (for stationary use)
-Set the base (12) of the column (11) and (13) and fasten them in the square holes of the seat with screws and nuts;
-regulator 2 set the required planing depth;
-Install the planer on the stand with the base facing up and fix it on the columns with screws (15);
-Install the protective casing (7) in the sleeve on the seat (with the flat side to the screw) up to the stop and fix
screw (14).
Note! The protective cover overlaps a part of the base and limits the area processed by the blades for 3-8 mm.
Rebating
For rebating, use the regulator (2) to set the maximum planing depth. Install the planing depth limiter (vertical limit
stop) in the planer front part on the side of the hinged cowl and secure it with a screw (15) in the hole. Adjust it to
the required sampling depth (maximum - 15 mm). If necessary, set the horizontal limit stop and adjust it to the
desired sample width. Sampling of the rebating is carried out in several passes.
Preparation for operation
-Set the planer depth regulator (2) to the "0" position;
- turn the planer upside down;
- Place a flat hard (metal, hard plastic or wood) part to the planer base so that it overlaps the drum groove, and
firmly press it;
-note the position of the each knife blades relative to the attached part.
If the knife blade edges during the drum rotates slightly touches the part - the blade is installed correctly.
If the blade does not touch the part, touches the part and / or does not allow the drum to rotate, then it is necessary to
adjust the position of the blade in accordance with Periodic maintenance.
Depending on the operation type, set the regulator (2) on the case mark the planing depth: the maximum depth - for
draft rough planing and rebating, the minimum - for hardwood and final processing.
To ensure your safety and the safety of surrounding objects, before powering on, install the fabrication on the safety
stop (10). To do this, lift the planer back part: the safety stop will open and you will be able to put the fabrication
without fear of contact of the drum with the supporting surface.