6
Assembly Instructions cont.
Step 5 Fitting the Poles to
the Portico Roof of Main tent
With the help of at least one other person,
select the two “grey fibreglass long roof poles
with navy sticker”. Insert the poles diagonally
from corner to corner of the tent roof. Ensure
the poles pass through the pole sleeves with
the navy trim. Insert the pole ends into the
corner portico hubs attached to the inner tent.
The correct hub is marked with navy tape, see
figure 4.
Now select the two “grey fibreglass roof poles
with red sticker”. Insert the poles through the
pole sleeves marked with the red trim that
run from side to side across the tent. Ensure
that these poles cross under the two “grey
fibreglass long roof poles with navy sticker”.
Place the ends of these poles into the portico
hubs located across the middle of the tent. The
correct hub is marked with red tape.
Finally select the two “black steel roof
reinforcement poles with yellow sticker”. These
are inserted into the portico hubs located
on the corners of the tent. These poles span
between each hub along the shortest side of
the tent. The correct hub is marked with yellow
tape.
HELPFUL HINT
Do not force pole through the sleeves as
this may damage the sleeve and could
break the pole. Check to ensure the pole
does not snag when sliding it through the
sleeve.
Figure 4
Step 6 Installing the Wall
Poles of Main tent
With the help of at least one other person,
select one of the four “black steel corner
poles with navy sticker”. Insert one end into
the corner portico hub with navy tape and
place the opposite end onto the ring and pin
assembly at the base of the tent floor, see figure
2. The tent will stand up during this process, see
Figure 5. Attach the pole clips located on the
inner tent, see Figure 6. Repeat this process for
the remaining three “black steel corner poles
with navy sticker”.
Figure 3
9.5m
m
116cm
x2
16mm
194cm
x4
19mm
70cm
x1
Ensuite Tent
