5
Select one of the six steel wall poles, insert an
end of the pole into the remaining opening of
the 2-way hub and insert the opposite end of
the pole onto the corresponding Pin and Ring
assembly at the base of the tent, the correct
pin is not directly below, the steel wall poles sit
inclined along the side wall at approximately
45 degrees, as indicated in Figure 9. Repeat this
process for the remaining five steel wall poles.
The tent will to stand up during this process.
Connect the J-Hooks attached to the inner tent
onto the poles, as indicated in Figure 5. Peg out
all remaining peg points around base of tent.
Assembly Instructions cont.
Figure 5
Figure 6
Figure 7
Step 6 Standing up the tent
Step 7 Attaching the Fly
Sheet
Lay the fly sheet out along the side of your tent.
Ensure that you have the front and the back
aligned correctly. Raise the fly sheet up and
carefully draw it over the top of your tent. Do
this slowly to avoid snagging the fly. Once the
fly sheet is on top of your tent, you can now
securely attach all of the Posibrace™ Velcro™
reinforcing points on the underside of the
fly sheet around the corresponding poles as
indicated in Figure 6. Now connect the hooks
along the base of the fly to the corresponding
ring around the base of the inner tent, as
indicated in Figure 7.
HELPFUL HINT
Helpful Hint Before attempting this step
it helps to open the doors of the tent. This
allows for the air to enter into the tent as you
raise it.
Figure 4
