background image

YOUR FAZER 3

EN

05

04

The mission of the Fazer series is to offer the most versatile speed wing possible with performance and 
ease of use for both foot launch and ski launch flying. The Fazer 3’s quick and precise launch characteristics 
are ideal for summer foot launching. The redesigned trimmer system offers a new mode of steep flight with 
reduced efficiency and increased stability for winter speed-riding.  At average wingloadings foot launching 
is attainable even for intermediate level pilots, and with trimmers released the wing’s glide performance is 
reduced to the point that carving terrain on skis or slowing the wing down for fully-unweighted ski turns 
becomes manageable. 

Thanks to its low aspect ratio and reduced sail weight, the Fazer 3 stays stable overhead and tracks with 
the skier effortlessly when weight is transferred away from the wing to the slope. While the available trim 
adjustment is significant, there is also plenty of glide range available using brakes only. This extended 
brake range is useful in situations where sink rate must be reduced, for instance when dynamic soaring in 
wind. The range is progressive and gives plenty of warning before stall. 

During the inflation, like its predecessor the wing snaps up immediately and symmetrically. The profile is 
reinforced at every cell, ensuring an open leading edge for quick inflation. With no tendency to overshoot, 
the Fazer 3 settles overhead and is ready for cliff launches, steep ski lines, or a running start. You can tailor 
the launch behavior to your needs by adjusting the trimmers to taste.

In flight the compact feeling of the Fazer 2 remains however the Fazer 3 is more dynamic. Roll behavior 
has been increased slightly, but remains very manageable. Barrel rolls are quicker and the wing continues 
through  the  roll  with  less  input  needed.  The  stability  makes  for  an  extremely  precise,  smooth,  and 
confidence-inspiring ride for pilots who are shaving terrain. 

We maintained the swoopable design and flare power of the Fazer 2, but improved speed in the dive. 
Transitioning out of the dive on brakes is highly effective and the large amount of energy retention in the 
wing makes it easy to shave off the altitude in tiny increments during your final turn. Risers can also be 
used, but gentle paragliding-style inputs are needed. The Fazer 3 is not a parachute. 

The Fazer 3 is ideal for experienced speed flying pilots when heavily loaded, but is still very suitable for 
newer pilots at lighter wingloadings. Choose your size carefully with the advice of your OZONE dealer or 
instructor. 

The Pack

The Mountain Pack is large enough to carry a standard harness and speed wing. It is also equipped with 
external straps that can be used to carry skis or snowboards and other equipment. We recommend always 
using appropriate safety and rescue equipment when traveling in the backcountry in snow conditions. 

The Atak Harness (Optional)

The  Atak  is  a  special  harness  developed  for  speed  wing  flying.  The  hang-points,  structure,  and  pilot 
positioning  are  all  specifically  engineered  for  speed-flying  pilots.  Your  Atak  harness  is  adjustable  for 
upright and semi-reclined flying, although most experienced speed flying pilots prefer to be in an upright 
position in order to move from seated to skiing quickly and easily. 

Brake Lines

The brake line lengths have been set carefully during testing. It should not be necessary to change the 
lengths. However, if you do choose to adjust them, do so in a progressive manner to ensure that they are 
not over-shortened.

Risers

Your wing has 3 risers per side. The A riser is covered with coloured webbing, which makes them easy 
to identify.

Trimmers

The trimmer system can be used to increase or decrease your angle of attack. We recommend becoming 
very familiar with your wing before using the trimmer system. 

Total weight in Flight

The wing has been successfully load tested, without destruction to above 6g with a load of 120kgs. Do not 
exceed 120kgs in flight. Choose the size suitable for your usual site and experience, do not fly the smaller 
sizes unless you are a very experienced speed flying pilot.

IMPORTANT

In the unlikely 

event of a brake line 

snapping in flight, or 

a handle becoming 

detached, the glider 

can be flown by 

gently pulling the rear 

risers (C-risers) for 

directional control.

IMPORTANT

Never fly with your 

trimmers released in 

turbulent conditions. 

Summary of Contents for Fazer 3













Reviews: