TSB-1208
3. OPERATING THE TABLE SAW
OPERATION
The tool is recommended for use with a residual current device
with a rated residual current of 30mA or less.
Push Stick
CAUTION!:
DO NOT USE THE TABLE SAW TO CUT
METAL OR MASONRY.
Turning On and Off
1. To turn the table saw ON,
slide the safety stop knob
up and lift the safety cover.
Workpiece
2. Depress the green
button (“I”) to start.
3. To Stop, either depress the red button (“O”) or firmly depress
the safety stop knob.
The push stick protects against accidental contact with the saw
blade.
Overload Protection
In the event of an overload a
thermal overload protection will
trip. Only after the table saw
cools down can it be restarted.
To restart, first press the
Reset button, then the green
On button (“I”) to restart.
Place the workpiece flat
on the table top with one
edge pressed against the
rip fence.
When making a cut push
workpiece in a steady
motion towards the rear
and cut in a single pass.
When cutting using the
mitre gauge, place the
workpiece flat on the table
top with one edge pressed
against the mitre gauge.
When making the cut push
mitre gauge forward
Set the saw blade to the required cutting
depth. The blade guard must rest with its
front edge on the workpiece.
Note:
Before performing a cut, ensure the blade is at full speed.
Failure to do this will cause the blade to become blunt and cause
the blade to lock-up.
