ONLINE MANUAL
Scan this QR Code with your
mobile device to take you to the
online manual.
1. Induction Motor
2. Electrical Box
3 Adjustable Foot
4 Carry Handle
5 Pumping Housing
6 Discharge Outlet
7 Priming Screw
8 Drain Plug
9 Suction Inlet
TRANSFER PUMP
KNOW YOUR PRODUCT
1. SUCTION INLET
Preparing the Pump: Your pump requires no assembly before
use other than the connection of a suitable inlet/outlet hose and
hose connections (not included).
NOTE:
The input hose or pipe you are using must
have a minimum diameter of 25.4mm (1’’).
NOTE:
Ensure the input hose or pipe is not
restricted in any way.
SETUP & PREPARATION
2. Remove the plastic protection
cover from the suction inlet
and insert a 1” male threaded
hose adaptor (not included).
Tighten firmly with a spanner (not
included).
3. Securely attach the input hose
or pipe to the other end of the
adaptor. Ensure you have the
correct diameter hose or pipe
that is compatible with your water
drawing source.
Connecting Hose or Pipe to the
Suction Inlet
1. Teflon tape (not included) is
required on threads to ensure a
water tight seal and prevent any
leakage. Wind Teflon clockwise on
fittings
Ensure the pump is disconnected from the power supply
before performing any of the following operations.