SSB-407
4. OPERATION
OPERATION
On/Off switch
• To turn the machine on, press
the green On (I) button.
• To turn the machine off, press
the red Off (O) button.
Note:
This variable speed scroll saw
is automatically turned off in the event of a power failure, accidently
unplugged or turned off at the mains power supply. You will need to
push the green On (I) button again to restart the variable speed scroll
saw.
Speed setting
The speed can be adjusted by turning the speed selector dial. Adjust
to suit the work piece/ material being cut. The saw’s speed can be
adjusted from 400 to 1,600 SPM (strokes per minute).
• Turn the machine On by pressing the
green On ( I ) button.
• Rotate the speed selector dial clockwise
direction for a higher or faster speed.
• Rotate the speed selector dial anti-
clockwise direction for a lower
or slower speed.
• Turn the machine Off by pressing
the red Off (O) button.
Note:
By using a scrap piece of timber to determine the optimum speed
by making a trial cut will increase the life of the saw blade.
Dust extraction port
This feature will allow Ø36mm attachments of
a vacuum hose for easy sawdust collection.
WARNING!
THE POWER SUPPLY FOR THIS
PRODUCT SHOULD BE PROTECTED BY A
RESIDUAL CURRENT DEVICE (RATED AT 30MA OR LESS).
A RESIDUAL CURRENT DEVICE REDUCES THE RISK OF
ELECTRIC SHOCK.
Bevel cutting
1. Loosen the Table Lock Knob to allow
the saw Table to be tilted to the left.
The saw table can be locked at any
angle from 0° to a 45° to the left for
bevel cutting. Turn lock knob clockwise
to lock.
2. A Bevel Scale is located under the saw
table as a convenient guide for setting
the appropriate table angle for bevel
cutting. The Bevel Scale is a guide
only, make a practice cut on scrap
material and adjust the saw table as
necessary for your desired setting.
Note:
When bevel cutting, the work piece holder can be adjusted so
that it is parallel to the saw table.
3. Loosen the screw at the front of the
work piece holder and then tilt so that it
is parallel to the saw table. Tighten the
screw to secure the work piece holder
in place.
15
0
15
0
OFF
ON
Sawdust blower
The variable speed scroll saw features
a sawdust blower to direct air to the
most effected point on the cutting
line. Make sure the work piece holder
is properly adjusted, to secure the
workpiece and direct air at the cutting
surface.
Internal cuts
This scroll saw allows you to carry out internal cuts in a panel, cuts not
starting at the edge of the work piece.
1. Remove blade as described in
“Fitting & removing blades”
.
2. Drill a appropriate size hole in the work piece.
3. Place the work piece on the Table with the drilled hole over the
centre of the Table Insert.
4. Install the blade through the drilled hole in the work piece and
through the Table Insert then adjust blade tension.
5. When you have completed the internal cuts, remove the blade as
described in
“Fitting & removing blades”
and then remove the
work piece.
