SNG-2000
4. OPERATING THE STAPLE NAIL GUN
5. TROUBLESHOOTING
1. Push the power
switch to the “I”
position.
3. Push the tool firmly
down on the work
surface to depress
the safety striker pin.
2. Place the staple
nail gun against the
work surface so that
the nosepiece of the
tool is where you
want the staple/nail
to be located.
4. Squeeze the trigger
switch to fire a
staple/nail.
Jammed Staple Nail Gun
Note:
Ensure the staple nail gun is switched off and unplugged
from the power supply before trying to remove any jammed nails.
1. Keep pressure on
the magazine latch.
2. Insert a small
flathead screwdriver
into the gap
between the nose
piece and the end
of the magazine.
3. Gently lever the screwdriver to pry the magazine open. Keep
pressure on the magazine latch until it can be fully depressed.
4. With the magazine
still open, tap the
safety striker pin
against a surface to
disloge any loose
staples.
NOTE:
The on/off trigger cannot be squeezed unless the safety
striker pin is fully depressed.
NOTE:
BE CAREFUL WHEN LEVERING THE
MAGAZINE OPEN. USING TOO MUCH FORCE
MAY BEND THE END OF THE MAGAZINE. IF THIS
OCCURS THE UNIT WILL BE INOPERABLE.
