MAINTENANCE
DESCRIPTION OF SYMBOLS
WARNING!
BEFORE CLEANING THE APPLIANCE OR
CARRYING OUT ANY MAINTENANCE PROCEDURE,
MAKE SURE THAT IT IS DISCONNECTED FROM THE
POWER SUPPLY TO PREVENT ACCIDENTAL STARTING.
Millimetre
Warning
Regulatory Compliance Mark
(RCM)
Double insulated
Wear eye, ear & breathing
protection
V
Volts
Hz
W
Hertz
~
bpm
J
mm
Alternating Current
Watts
beats per minute
Joules
Read Instruction Manual
Power tools that are no longer usable should not
be disposed of with household waste but in an
environmentally friendly way. Please recycle where
facilities exist. Check with your local council authority for
recycling advice.
Recycling packaging reduces the need for landfill and raw
materials. Reuse of recycled material decreases pollution
in the environment. Please recycle packaging where
facilities exist. Check with your local council authority for
recycling advice.
CARING FOR THE ENVIRONMENT
SPARE PARTS
Spare parts can be ordered from the Special Orders Desk at your
local Bunnings Warehouse.
For further information, or any parts not listed here, visit
www.ozito.com.au or contact Ozito Customer Service:
Australia 1800 069 486
New Zealand 0508 069 486
E-mail: [email protected]
Cleaning
1. We recommend that you clean the appliance immediately after
you use it.
2. Keep the safety devices free of dirt and dust as much as
possible. Wipe the equipment with a clean cloth.
3. Clean the appliance regularly with a damp cloth and some soft
soap. Do not use cleaning agents or solvents; these may be
aggressive to the plastic parts in the appliance. Ensure that no
water can get into the interior of the appliance.
Gear Box Grease Replenishment
WARNING!
WEAR GLOVES WHEN HANDLING GREASE.
The grease in the gearbox will require replenishment after
approximately 50 hours accumulative use. After this time, add
approximately 50 grams (approximately 2 – 3 teaspoons) of the
grease (supplied), into the gearbox.
First remove the grease cap from the
drill by using the pin spanner. Once
removed, add the grease through this
hole. Ensure the grease cap is secured
back into position prior to operation. If
additional grease is required, please
contact Ozito Customer Service.
Carbon Brushes
When the carbon brushes wear out, the drill will spark and/or
stop. Discontinue use as soon as this happens. They should be
replaced prior to recommencing use of the drill. Carbon brushes
are a wearing component of the drill therefore not covered under
warranty. Continuing to use the drill when carbon brushes need
to be replaced may cause permanent damage to the drill. Carbon
brushes will wear out after many uses but when the carbon
brushes need to be replaced, take the drill to an electrician or a
power tool repairer for a quick and low cost replacement. Always
replace both carbon brushes at the same time.
Storage
Pull the mains plug out of the socket, switch off the tool and make
sure that it is secured in such a way that it cannot be started up
again by any unauthorised person. Store the tool in a dry location
which is not accessible to unauthorised persons.
Supply Cords
If replacement of the supply cord is necessary, this has to be done
by a certified electrician in order to avoid a safety hazard.
Note:
Ozito Industries will not be responsible for any damage or
injuries caused by the repair of the tool by an unauthorised person
or by mishandling of the tool.
900W
ROTARY
HAMMER
