Using The Dust Cover
The cover catches dust and debris whilst using the drill upright or
overhead.
1. Slide the cover over the end
of the accessory.
2. Add lubrication grease.
3. Insert the drill bit into the
chuck as per usual.
4. Press the dust cover to the
end of the locking sleeve.
900W
ROTARY
HAMMER
900W
ROTARY
HAMMER
Installing SDS+ Accessories
1. Before using a drill bit in the hammer
drill, ensure that the SDS+ accessory is
clean of dust and debris.
2. Dip the SDS+ end of the accessory into
the supplied tub of grease.
WARNING!
WEAR GLOVES WHEN HANDLING GREASE.
3. Insert the SDS+ accessory
into the chuck.
Note:
The locking sleeve
should not be pulled back
when inserting the accessory.
4. Rotate the accessory until it
is inserted as far as possible
into the locking sleeve.
Note:
You should hear a click
when it is correctly inserted.
5. Pull on the SDS+ accessory
to check it is locked in.
Note:
It should leave
approximately 10-20mm of
movement. This is normal.
6. To remove the SDS+
accessory, pull back the
locking sleeve and pull the
accessory out.
1500W
ROTARY
HAMMER
900W
ROTARY
HAMMER
900W
ROTARY
HAMMER
900W
ROTARY
HAMMER
