MAINTENANCE
• Keep ventilation slots of the jigsaw clean at all times to ensure efficient
operation.
• After each use, blow air through the tool housing to ensure it is free from all
dust, dirt, etc. Build up of dust, dirt particles may cause the tool to overheat and
shorten the life of the tool.
• If the housing of the jigsaw requires cleaning, do not use solvents but a moist
soft cloth or soft brush only.
• Never let any liquid get inside the tool, never immerse any part of the tool into
liquid.
• No lubrication is necessary as the tool has sealed bearings.
• When not in use, the jigsaw should be stored in a dry, frost free location not
within the reach of children.
WARNING!
ALWAYS ENSURE THE TOOL HAS
COMPLETELY STOPPED AND THE BATTERY IS REMOVED
PRIOR TO ANY MAINTENANCE.
Battery protection system
The tool is equipped with the battery protection system, which helps to
ensure a long service life.
The output power automatically cuts off during operation when the tool and/
or battery are placed under the following situations:
• When the tool is overloaded:
If this occurs, release the trigger switch and remove causes of overload,
then pull the switch trigger again to restart.
• When the remaining battery capacity becomes low:
Recharge the battery pack.
Note:
The battery protection system does not in any way damage the tool.
Note:
The indicated capacity may be lower than the actual level during use
or immediately after using the tool.
7. CUTTING
8. POCKET CUTTING
OPERATION
2 Mark your cutting line with a
pencil or attach the parallel
guide.
4 Start the jigsaw by holding the
lock-off switch and depressing
the on/off trigger.
1 Ensure the correct
blade is inserted into
the blade lock and is
secure.
3 Place the base onto
the workpiece with
the blade away from
the edge.
5 Move jigsaw forward
with light pressure.
Allow the blade to
stop before lifting
the jigsaw away.
A pocket cut is when you need to cut a hole in the middle of a
workpiece
2 Pass the blade through the hole and begin the cut.
1 Drill a hole in the
workpiece using a
12mm bit.
Note: Ozito Industries will not be responsible for any damage or injuries
caused by the repair of the jigsaw by an unauthorised person or by mishandling
of the jigsaw.
Note:
If the jigsaw switches off during use, the tool
is overloaded. Please reduce cutting pressure and/or
increase pendulum action to reduce load on the tool.
