5. SHOE ANGLE & DUST EXTRACTOR
1 Hold the lock-off
switch down and
then squeeze the
on/off trigger to start
the jigsaw.
Switching On and Off
Adjusting the Cutting Action
2 To stop operation,
release the on/off
trigger.
6. CONTROLS
OPERATION
PXJSS-600
The angle of the shoe can be adjusted to allow for bevel cuts
between 0 and 45
°
.
2 Slide the shoe forwards
and tilt the shoe to the
desired angle using the
measurements.
1 Push the shoe locking
lever to the right to
unlock the adjustable
shoe.
3 Once the angle is
correct slide the
shoe back for the
pins to make contact
and secure in place
by pulling the shoe
locking lever left.
A dust extractor can be fitted to the jigsaw dust extraction
adaptor to remove dust and chips while cutting. The adaptor
can also be removed if it gets in the way.
Dust Extraction Adaptor
Adjusting the Shoe Angle
1 Fit the dust extraction adaptor to the jigsaw by pushing it
into its slot from the back.
2 To remove simply slide the dust extraction adaptor from
the back of the jigsaw.
The jigsaw has a pendulum action feature which enables
the blade to cut faster and more efficiently in thick and softer
materials. See below for a guide on choosing the correct
setting.
1 To use the pendulum action,
rotate the pendulum action
selector clockwise to a higher
setting.
2 To use standard cutting
action, rotate the pendulum
action selector anti-clockwise
to a lower setting.
1 -
No pendulum action for fine clean cuts
on thin or hard materials
2 -
Small pendulum action for faster
cutting on hard materials
3 -
Medium pendulum action for faster
cutting on softer materials
4 -
Large pendulum action for fast cutting
along the grain on soft materials.
