BATTERY & CHARGER
This tool is compatible with all battery and chargers from the Ozito
Power X Change Range.
ONLINE MANUAL
Scan this QR Code with your
mobile device to take you to the
online manual.
1. Battery Cover
2. Carry Handle
3. Pump Setting Switch
4. Discharge Outlet
5. Priming Plug
6. Drain Plug
7. Suction Inlet
CORDLESS GARDEN TRANSFER PUMP
KNOW YOUR PRODUCT
1. INLET & OUTLET
SETUP & PREPARATION
1
2
3
4
5
6
7
WARNING!:
ENSURE THE TOOL IS OFF AND THE
BATTERIES ARE REMOVED BEFORE PERFORMING
ANY OF THE FOLLOWING OPERATIONS.
1. Thread seal tape (not included) is
required on threads to ensure a
water tight seal and prevent any
leakage. Wind thread seal tape
clockwise on fittings.
Note:
The input hose or pipe you are using must have a minimum diameter
of 25.4mm (1”).
Preparing the Pump: Your pump requires no assembly
before use other than the connection of a suitable inlet/
outlet hose and hose connections (not included).
2. Remove the plastic protection
cover from the suction inlet
and insert a 25.4mm ( 1”)
male threaded hose adaptor
(not included). Tighten firmly
with a spanner (not included).
3. Securely attach the input
hose or pipe to the other
end of the adaptor. Ensure
you have the correct
diameter hose or pipe that is
compatible with your water
drawing source.
WARNING!:
ENSURE THE INPUT HOSE OR PIPE
IS NOT RESTRICTED IN ANY WAY.
Connecting Hose or Pipe to the Suction Inlet
Note:
A leaking hose or pipe will draw in air and therefore not draw in any
water.
